JETTED SINK
Use & Care Guide
For questions about features, operation/performance, parts accessories
or service call: 1-800-253-1301
or visit our website at... www.whirlpool.com
Table of Contents ................................................ 2
8537099B
PARTS AND FEATURES
E
F
A
B
G
H
C
D
I
J
Standard features
A. Automatic pop-up drain control
B. High-gloss acrylic sink
C. Micro-jets (3)
Parts not included
Faucet
F. Jet speed control
G. Timer
H. Suction cover
D. Washboard front (not shown)
E. On/off button
I. Pump/motor
J. Model/serial number label (not shown)
JETTED SINK USE
The jetted sink is to be used for washing delicate clothing such
as lingerie, hosiery, blouses or a single sweater.
IMPORTANT:
Starting Your Jetted Sink
I
The jetted sink should not be used for bathing infants or pets.
A
B
C
I
The jetted sink should not be used for cleaning or soaking
unusually dirty, or clay-ridden clothing, household tools or
other items that may damage the inner plumbing system and
pump.
A. Pop-up drain control knob
B. On/off button
C. Jet speed control knob
I
I
Do not overfill with laundry. The jetted sink is not designed to
replace a washing machine.
Do not run the pump/motor on the jetted sink while the
suction cover is off or without water in the jetted sink. This
could cause damage to the pump/motor or internal seals and
could void the warranty.
NOTE: Before washing, pretreat stains on clothing according to
the recommendations on the garment care label.
1. Turn the pop-up drain control knob counterclockwise to close
the drain.
Loading
2. Fill jetted sink with water to just above the suction cover.
Dye transfer can occur when mixing whites and colors in a load.
Sort dark clothes from whites and lights.
IMPORTANT:
I
I
The water must completely cover the suction cover.
Only clothing labeled as hand or machine washable should be
loaded.
The water temperature should be what is recommended
for the garments being washed.
Suggested Loads for Jetted Sink
3. Add a few drops of low-sudsing, delicate washing liquid
detergent or 1 tsp (4.9 mL) of a low-sudsing powder at any
time after you have started running water into the jetted sink.
You may add more if necessary.
Clothing
Number of Pieces
Bulky sweaters
1
NOTES:
Fine knits, blouses, swim wear
Lingerie, hosiery
3
I
Some delicate wash detergents foam excessively when
agitated. It may be necessary to rinse the jet system and
clothing with clean water after use.
3-5
I
Do not use fabric softener.
3
4. Load a few small items of delicate clothing or a sweater into
10. After rinse is finished, drain the rinse water from the jetted
sink and gently squeeze water from garment without twisting
or wringing. Additional water can be removed by laying
garments flat on a clean, dry towel. Roll up the towel, then
gently squeeze out excess water. Follow recommendations
on the garment care label for drying.
the jetted sink.
5. Set the jet speed control for desired water force/speed. See
“Jet Speed Control.”
6. Press the on/off button to start the pump/motor and to set
the 10-minute timer. The on/off button sets the timer to shut
off automatically in 10 minutes, but the on/off button can also
override the timer and stop the pump/motor at any time.
Jet Speed Control
IMPORTANT: Starting the pump when there is no water in the
jetted sink could result in damage to the pump or internal seals
and could void the warranty.
Water pressure in the jetted sink may be adjusted from a very
high agitation (H) to a low, swirling action (L) by turning the jet
speed control dial.
7. After wash is finished, turn pop-up drain control knob
clockwise to open the drain.
Normal Sounds
Your jetted sink may make sounds that are unfamiliar to you.
The normal sounds are:
8. Gently squeeze water from garment(s) without twisting or
wringing.
9. Close the drain again, turning the pop-up drain control knob
counterclockwise as before. Fill the jetted sink with clean
water, reset the jet speed control, and push the on/off button
to begin another 10-minute cycle to rinse garment(s).
During washing
You will hear the sound of the pump and motor operating.
During draining
You will hear the sound of water draining from the sink.
JETTED SINK CARE
Cleaning Your Jetted Sink
Storing
Acrylic is a renewable surface. If the acrylic surface is damaged,
minor cuts or scratches usually can be buffed or polished out of
the finish with a paste wax or automobile rubbing compound.
To winterize your jetted sink:
IMPORTANT: The jetted sink must be filled to a level above the
suction cover.
To clean your jetted sink:
1. Fill the jetted sink with an R.V.-type antifreeze solution to just
I
Clean the acrylic surface with a mild, liquid detergent and a
damp cloth or sponge. Rinse and wipe dry with a soft cloth.
above the suction cover.
2. Run the jetted sink for a 10-minute cycle.
3. Unplug jetted sink or disconnect power.
4. Shut off the water faucet.
I
Do not use abrasive cleaners such as scouring cleansers or
harsh cleaning tools such as scouring pads. These can
scratch or damage materials.
5. Disconnect the water inlet hoses from faucets and then drain.
To flush your jetted sink:
To use your jetted sink again:
1. Flush the water pipes.
2. Reconnect the water inlet hoses to faucets.
3. Turn on both water faucets.
Flush the jetted sink at least once every 90 days.
1. Fill the jetted sink with hot water and add 2 tsp (9.8 mL) of
non-sudsing laundry detergent.
2. Run the system for 10 minutes, then drain the jetted sink.
4. Plug in jetted sink or reconnect power.
3. Fill jetted sink with cold water and run for 10 minutes to rinse
the system, then drain the jetted sink.
5. Run the jetted sink through a 10-minute cycle with ¹⁄₄ the
normal recommended amount of detergent to clean out the
antifreeze.
TROUBLESHOOTING
First try the solutions suggested here and possibly avoid the cost of a service call...
I
Is the clear air-line hose connected to both the bottom of
the timer control box and the bottom of the on/off button?
Jetted sink pump/motor won’t turn on
I
Is the reset button on the GFCI tripped?
I
Is the power cord plugged into the timer control box
outlet?
Jetted sink won’t drain
Is the drain clogged?
I
I
Is the timer control box plugged into the wall outlet?
Has a fuse blown, or has the circuit breaker tripped? If
problem continues, call electrician.
I
I
Is the drain plug adjusted correctly? Adjust the drain plug
height by turning the adjusting screw on the bottom of the
drain plug. See Installation Instructions.
I
Is there power at the plug? Check electrical source or call
electrician.
4
Jetted sink makes noise
Gray whites, dingy colors
I
I
Is the pump/motor plugged into an outlet? The on/off
button will make a clicking noise if you push the button when
the power cord is not plugged into the timer control box
outlet.
I
I
I
Did you properly sort the load? Dye transfer can occur
when mixing whites and colors in a load. Sort dark clothes
from whites and lights.
Was the proper amount and type of detergent used? Use
a few drops of low-sudsing, delicate washing liquid detergent
or 1 tsp (4.9 mL) of a low-sudsing powder.
Is the water level too low?
Jetted sink leaks
Did you use the proper water temperature? Follow the
garment manufacturer’s care label instructions.
I
I
I
I
Check caulking around jetted sink for leaks.
Check household plumbing for leaks.
Is the drain clogged?
Garment damage
I
Check the following:
Were sharp items removed from pockets before washing?
Is water deflecting off the jetted sink or the load? The
jetted sink should not be overloaded. The incoming water
might deflect off the load.
Empty pockets, zip zippers, and snap or hook fasteners
before washing.
I
Did you fill the jetted sink with too much water? The jetted
sink should be filled to just above the suction cover.
Were strings and sashes tied to prevent tangling?
I
I
Were items damaged before washing? Mend rips and
broken threads in seams before washing.
Stains on clothing
Was chlorine bleach used in the jetted sink? Rinse the
jetted sink well and wipe up bleach spills which could transfer
to clothing causing damage.
I
I
I
I
Is there above average iron (rust) in water? You may need
to install an iron filter.
Did you properly sort the load? Sort dark clothes from
I
I
Did you overload the jetted sink? The jetted sink must not
whites and lights.
be overloaded. Clothes should move freely during washing.
Did you unload the jetted sink promptly? To avoid dye
transfer, unload the jetted sink as soon as it stops.
Did you follow the garment manufacturer’s care label
instructions?
Was the jetted sink used for household cleanup and not
cleaned properly? See “Cleaning Your Jetted Sink.”
ASSISTANCE OR SERVICE
Before calling for assistance or service, please check
“Troubleshooting.” It may save you the cost of a service call. If
you still need help, follow the instructions below.
I
I
Accessory and repair parts sales.
Specialized customer assistance (Spanish speaking, hearing
impaired, limited vision, etc.).
When calling, please know the purchase date and the complete
model and serial number of your appliance. This information will
help us to better respond to your request.
I
Referrals to local dealers, repair parts distributors, and
service companies. Whirlpool designated service technicians
are trained to fulfill the product warranty and provide after-
warranty service, anywhere in the United States.
If you need replacement parts
If you need to order replacement parts, we recommend that you
use only FSP® replacement parts. FSP® replacement parts will fit
right and work right because they are made with the same
precision used to build every new WHIRLPOOL® appliance.
To locate the Whirlpool designated service company in your
area, you can also look in your telephone directory Yellow
Pages.
To locate FSP® replacement parts in your area, call our Customer
eXperience Center telephone number or your nearest Whirlpool
designated service center.
For further assistance
If you need further assistance, you can write to Whirlpool
Corporation with any questions or concerns at:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
In the U.S.A.
Call the Whirlpool Customer eXperience Center
Benton Harbor, MI 49022-2692
toll free: 1-800-253-1301.
Please include a daytime phone number in your correspondence.
Our consultants provide assistance with:
I
I
I
Features and specifications on our full line of appliances.
Installation information.
Use and maintenance procedures.
5
WHIRLPOOL™ JETTED SINK WARRANTY
ONE-YEAR LIMITED WARRANTY
For one year from the date of purchase, when this jetted sink is operated and maintained according to instructions attached to or
furnished with the product, Whirlpool Corporation will replace defective parts with factory authorized parts to correct defects in
materials or workmanship, when presented to the selling distributor, together with proof of purchase, during the warranty period.
Service must be provided by a Whirlpool designated service company.
Whirlpool Corporation will not pay for:
1. Service calls to correct the installation of your jetted sink, to instruct you on how to use your jetted sink, or to replace house fuses or
correct house wiring or plumbing.
2. Repairs when your jetted sink is used in other than normal, single-family household use.
3. Damage resulting from accident, alteration, misuse, abuse, fire, flood, acts of God, improper installation, installation not in
accordance with local electrical and plumbing codes, or use of products not approved by Whirlpool Corporation.
4. Damage resulting from activating the whirlpool jet action with no water in the jetted sink or with water level below the jets.
5. Damage caused by failure to test the unit properly prior to complete enclosure.
6. Any labor costs during the limited warranty period.
7. Replacement parts or repair labor costs for units operated outside the United States.
8. Pickup and delivery. This product is designed to be repaired in the home.
9. Repairs to parts or systems resulting from unauthorized modifications made to the appliance.
10. Products classified as options or accessories, although they may be covered under their own manufacturers’ warranties.
WHIRLPOOL CORPORATION SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so this exclusion or limitation may not
apply to you. This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
Outside the 50 United States, this warranty does not apply. Contact your authorized Whirlpool dealer to determine if another
warranty applies.
If you need service, first see “Troubleshooting.” Additional help can be found by checking “Assistance or Service,” or by calling our
Customer eXperience Center at 1-800-253-1301, from anywhere in the U.S.A., or write: Whirlpool Brand Home Appliances,
Customer eXperience Center, 553 Benson Road, Benton Harbor, MI 49022-2692.
10/02
Keep this book and your sales slip together for future
Dealer name____________________________________________________
reference. You must provide proof of purchase or installation
date for in-warranty service.
Address________________________________________________________
Phone number__________________________________________________
Model number __________________________________________________
Serial number __________________________________________________
Purchase date __________________________________________________
Write down the following information about your jetted sink to
better help you obtain assistance or service if you ever need it.
You will need to know your complete model number and serial
number. You can find this information on the model and serial
number label/plate, located on the pump/motor underneath the
countertop.
8537099B
© 2004 Whirlpool Corporation.
7/04
Printed in U.S.A.
All rights reserved.
® Registered Trademark/TM Trademark of Whirlpool, U.S.A.
|